pel.ly

Tag: network

Home Networking Project

by on Feb.22, 2012, under Networking, Projects

As we were getting the attic converted, I decided to take the opportunity to wire the house up for Cat5e and have Node Zero located in the attic.

Equipment:
1 Data Cabinet (6u)
1 Patch Panel
1 Cable Organiser
1 Fanless Gigabit Router
1 Reel of Cat5e
Cat5e Euro modules
16 30cm patch cables
1 Cat5e Crimping Tool
1 Push Down  Krone Tool

I picked up the data cabinet with patch panel and organiser on adverts.ie for €50.  I decided to try and source a fanless router as the attic would also be used as a guest bedroom.   I came across a HP V1410-16G 16 Port Gigabit Switch on misco.ie for €90 (plus €18 delivery) which was a heck of a lot cheaper than I could find elsewhere.  Although it seems I may have gotten that as a misprice as its currently €148 (plus €18 delivery) which is similar to what it was on other website, happy days indeed :)

OK, lets go!

So the plan was to drop 4 Cat5e cables in each room.  At most, probably only 2 would be used but it was just as easy to drop 4 instead and future proof the installation somewhat.

Initial Drilling in Stud Wall

Initial drilling in stud wall partition

Having cut out a section of the dry wall using the lining box as a template, I borrowed some cable rods from a buddy which allowed the cables to be pulled through easily.  Those cable rods are kinda expensive but they really are worth their weight in gold.. I’m so glad my buddy bought them :)

Dry Wall Cut Out

Dry wall cut out with cable rod

 

Cable attached to cable rod

Time to start pulling the first cable through

 

First cable pulled through

Et viola, the first cable is pulled

Rinse and repeat for the remaining 3 cables and then fit the dry lining box.  Note the labelled cables to help with identification.

Lining Box with cables

The lining box fitted with all 4 cables pulled through

Each module was connected using the Krone tool, this is probably the most boring part of the whole project :)

Completed sockets

Completed sockets

Here is the eventual location of where the cabinet will be and where Node Zero will be housed. You can see some of the cables already routed in the background.

Eventual Node Zero

The eventual location of the cabinet housing Node Zero

 

Cabinet

The attic conversion progresses and the cabinet begins to take shape.

I was a little concerned about the amount of space there would be for opening the door of the data cabinet.  It turned out that there was a couple of mm of a gap to spare.

Fitting of data cabinet

The data cabinet gets tried out for size, it fits and the door can just about be opened

 

New sockets

The sockets get added

 

Data Cabinet and sockets

The sockets will be hidden from view once the data cabinet door is closed

 

Cut out for cables

The cut out for the cables to pass through was next

 

Draft Excluder

In order to prevent any unwanted drafts, I covered the cut out with a standard letter box draft excluder

 

The finished article

The data cabinet in place and all equipment connected

The box on top is a SamKnows white box which is used to gather reliable and accurate statistics as part of an EU wide study on broadband performance which I’m taking part in.

Some cable management required for the router/DSL modem

Internal view of the fully connected data cabinet. Some cable management required for the router/DSL modem though...

And that’s it! Its been a nice project to finally get done and have all the equipment neatly stored away and out from the reach of small hands :)

 

Leave a Comment :, , , more...

Looking for something?

Use the form below to search the site:

Still not finding what you're looking for? Drop a comment on a post or contact us so we can take care of it!